MakerWorld
Hueforge & Lithophane
Haunted
by Corp
4
Downloads
8
Likes
1
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can adjust X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA PolyLite Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA PolyLite Grey Transmission Distance: 1PLA PolyLite White Transmission Distance: 5This print uses 4 unique filaments. Substitute as ne
Sign in to leave a comment
Sign in