Hawk Capture Rabbit

This is another one i created using ai and a lot of different prompts to get to this. i used Gemini to create the image while using makerworld to get the 3d model and stl file. i used an ender3 base model which took about 7 1/2 hrs using about 28 grams of filament and it cost around $0.62 according to cura. i also changed the x size to 66mm and kept uniformed scaling to print this. i believe the original size should take a little over 16 hours. i am also including another model i did with a little more detail on the branch

spec
printed model at 66mm
infill is 20% but for this size i dont it really mattered
adhesion enabled
support tree enabled
infill used grid but i dont think it really matter at 66mm
printed at 220 C
bed 55 C