Hayward Skimmer Support

This support bracket is for the Hayward Skimmer that attaches to above ground pools. It is designed for the wide mouth kit, but can easily be cut to a short length if using the small mouth version. It is designed to print all 3 pieces the coupler will go in the middle between the 2 pieces. Once you have the proper length cut, use a little super glue inside the coupler and slide the 2 pieces together. I also added on some Rubber weather stripping on both ends to hold them in place once installed, as well as to put a protective barrier between the pool liner and the bracket

If printing and using it as is, id suggest PETG or equivalent material that won't warp, printed at 50-75% infill.

If you are going to cut it and adjust the length, print it at 100% infill same PETG or equivalent material.