Thingiverse
Robotics
Zum Modell
HC-SR04 Case
162
Downloads
103
Likes
4
Makes
I created this as a learning exercise for Fusion 360, but it may be of some use. I screwed the two halves together with M1.5x5 screws.
The v2. version of the bottom piece has a widened hole so that a 4 pin DuPont connector will fit.
The v2. version of the bottom piece has a widened hole so that a 4 pin DuPont connector will fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
