Thingiverse
HC-SR501 Case
door beermeister
6
Downloads
6
Likes
0
Makes
Case for IR-Sensor HC-SR501.
Use two 3.5x16mm Spax Screws. The Screws don't touch the PCB. They press the two parts together with the HC-SR501 between them.
Both Potis are accessible through two holes.
The hole on the side fits a LiYCY 3 x 0.50 mm² Cable (i.e. LAPP 0034603) with a outer diameter of 5.9mm.
For the picture i screwed it on a painted wooden plate.
Use two 3.5x16mm Spax Screws. The Screws don't touch the PCB. They press the two parts together with the HC-SR501 between them.
Both Potis are accessible through two holes.
The hole on the side fits a LiYCY 3 x 0.50 mm² Cable (i.e. LAPP 0034603) with a outer diameter of 5.9mm.
For the picture i screwed it on a painted wooden plate.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!