Slicer Discord
HC-SR501 PIR case – 3D-Druckmodell von Thingiverse Thingiverse
HC-SR501 PIR case – Bild 1 HC-SR501 PIR case – Bild 2 HC-SR501 PIR case – Bild 3 HC-SR501 PIR case – Bild 4 HC-SR501 PIR case – Bild 5

HC-SR501 PIR case

von assin
236 Downloads
135 Likes
2 Makes
Zum Modell
Housing for the HC-SR501 PIR motion detector.

I made this housing because i needed something to install the PIR into a ABS case from an electronics store. Drilled a 23mm hole into the ABS case and glued this thing on the inside. Don't forget to insert the two nuts before gluing. Screws are M3x12.

This PIR case was inspired by this thing https://www.thingiverse.com/thing:266912.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen