Thingiverse
HDD adapter - 2.5
door Buback
465
Downloads
374
Likes
22
Makes
A simplified version of kparlin's laptop HDD adapter. Much less plastic used, and only a single print, instead of 5.
**v3- Made the holes a bit bigger and walls a bit thicker. Also replaced the 3 cross-members with just one, because it was taking a long time to print the 3 thin cross-members.
*Update 8/10/11* Added adapter that just uses bottom screws of the 2.5 inch drive, and no crossmembers. This design also has the middle mounting screw often found on 3.5 inch drives and cases.
**v3- Made the holes a bit bigger and walls a bit thicker. Also replaced the 3 cross-members with just one, because it was taking a long time to print the 3 thin cross-members.
*Update 8/10/11* Added adapter that just uses bottom screws of the 2.5 inch drive, and no crossmembers. This design also has the middle mounting screw often found on 3.5 inch drives and cases.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
