Thingiverse
HDD holder
por Algok
0
Descargas
2
Likes
0
Makes
Purged case-container. The two halves snap into place when closed. For mounting in place of a 2.5' drive on the back of the computer.
To increase the strength of the connection between the lid and the bottom, after printing, tighten the lid with thread clamps and keep it in the oven for 10-20 minutes at 50 degrees Celsius (for PLA). This will change the original angle of the clips. Be careful, this operation can ruin the model.
The weakest point of the design is the holes at the base of the latches, printing with increased infill is desirable
To increase the strength of the connection between the lid and the bottom, after printing, tighten the lid with thread clamps and keep it in the oven for 10-20 minutes at 50 degrees Celsius (for PLA). This will change the original angle of the clips. Be careful, this operation can ruin the model.
The weakest point of the design is the holes at the base of the latches, printing with increased infill is desirable
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
