HDZ 5.0

Left and right mounting brackets were created independently via measurements taken from the side rails and the HDZ 5.0. They mount flush to the rear of back plate just beneath the drag chain supports. I cleaned out some material of the mounting holes for attaching them to the HDZ with a 15/64 drill bit (since I used M6 screws). I used two M6 20mm (25mm if using a washer) socket head screws and nuts to secure them through the top mounting holes of the HDZ. I did not recess the area for the mounting nuts, because I had some problems with this during testing (stripped the plastic with the nut on one and took awhile to remove). You will need four M5 25mm button head screws and nuts to secure the side rails to the left and right mounting brackets. The nuts press fit into the recesses on the rear of the mounting brackets.

I used PwnCNC's arms angling and offsetting one for each side inward by 10.5mm. I also trimmed the gradual angle found on the user side of the arms and centered t