HDZero Goggle VRX Combo Antenna Mount

This is a mount for TrueRC X2-Air antennas. It will allow you to mount the switch the same antenna back and forth between the VRX4 and the HDZero goggles.

Printing:
Print one normally. The other mount should be mirrored on either the X or Y axis. I printed using PLA without supports and the open end of the "C" facing down on the print bed.

Mounting:
In order for the outer rails to clear the VRX SMAs, make sure you mount these with the cut out at the top side of the antenna. You should test fit on the VRX before mounting to your antennas. Stick with double sided tape, such as VHB.