Thingiverse
Headboard Stop
door _slinky_
26
Downloads
16
Likes
0
Makes
When the headboard keeps banging on the wall, simply fit two of these to the back and adjust the knob to tighten the board. You can either stick one side to the wall with 3M tape, or just place it on the back.
In the closed position the height is 30mm and will screw out to 40mm, if you want a taller screw you can increase the Z height for both parts, I have tested the Z height up to 160% and the threads were fine. (opening to 100mm)
As aways with any printed threads, they work better with a little silicone spray at first.
In the closed position the height is 30mm and will screw out to 40mm, if you want a taller screw you can increase the Z height for both parts, I have tested the Z height up to 160% and the threads were fine. (opening to 100mm)
As aways with any printed threads, they work better with a little silicone spray at first.
_slinky_ publiceert ook op
16 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
