Headphone and Controller stand

I have made a headphone and controller stand made out of plywood because it is relatively cheap and an eco-friendly resource. you can also purchase it in 4mm thickness, which is what most of the stand is made out of. It is also lightweight and it is easy to construct and put away within minutes. it is made from five separate laser-cut pieces of wood and a 3d printed piece that slides on top of the smallest stand so that it can hold a controller. you can construct the stand by sliding the matching length pieces inside each other and then when they are together you place them in the + that are cut into the base of the headphone and controller stand. And then connect the 3d piece to the smallest stand and it's done.