Thingiverse
headphone and controller stand
von Siggi7
3
Downloads
1
Likes
0
Makes
prints well and took my printer 26 hours
printed on 10% infill with 2 walls
0.3mm layer height
supports not needed
file is oriented in correct orientation for printing
printed on 10% infill with 2 walls
0.3mm layer height
supports not needed
file is oriented in correct orientation for printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!