Thingiverse
Headphone Hanger
by andranch
7
Downloads
3
Likes
0
Makes
Needed a headphone hanger for my work desk, so i made one!
Can be quickly printed without support.
Print time is around 40 minutes with a Volcano hot-end 1,2 mm nozzle.
Print shown in pictures printed on CR10 s4 with Volcano 1,2 nozzle and white PLA.
Mounts with three small screws to the underside of your desk.
Can be quickly printed without support.
Print time is around 40 minutes with a Volcano hot-end 1,2 mm nozzle.
Print shown in pictures printed on CR10 s4 with Volcano 1,2 nozzle and white PLA.
Mounts with three small screws to the underside of your desk.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
