Thingiverse
Headphone hanger
von hikari5r
2
Downloads
3
Likes
0
Makes
This headphone hanger is used by inserting magnets.
Three magnets of 20mm dia. x 4mm thick are used.
Since it is difficult to remove the support material if it is made as is, I recommend splitting it in two in the middle and gluing them together later.
Three magnets of 20mm dia. x 4mm thick are used.
Since it is difficult to remove the support material if it is made as is, I recommend splitting it in two in the middle and gluing them together later.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
