Headphone Holder Remixed

Basically the same design as DeepDiverDude's original but redrawn in F360 from scratch.

Has a smaller fillet (2mm) on the inside corner, as the large fillet in the original did not fit my monitor.

I also made a version with no fillet on the inside corner, if you need that.

Also has bevelled top and bottom edges, to help with any bottom-layer squish and should help to avoid creating any sharp corners for the headband pad to sit on.

Unless your print bed creates a nice surface, print it so that the top side will face towards you (flip it over if need be).