Thingiverse
Headphone Holder
von KyleButler
2
Downloads
1
Likes
0
Makes
This headphone holder was developed for assembling with a screw.
The hole for the screw has a diameter of 6 mm, so you can use a M5 or other suitable screws.
I printed it with the flat site on the print bed. In this alignment you need support for the print.
After the print i removed the support with a thin plier.
All dimensions in the picture are in millimeter (mm).
The hole for the screw has a diameter of 6 mm, so you can use a M5 or other suitable screws.
I printed it with the flat site on the print bed. In this alignment you need support for the print.
After the print i removed the support with a thin plier.
All dimensions in the picture are in millimeter (mm).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
