Thingiverse
Headphone Hook for Desk
por JimmerJammer
11
Descargas
9
Likes
0
Makes
I made these for some inexpensive "Cowin" bluetooth headphones. There's a centered, rounded ridge to reduce the flexing that could occur with 90-degree angles.
The PETG headphone hook in the picture has been in use for 4 months - no warping.
Measurements:
The desk edge is 26mm thick. The gap for the headphone to slide in is 18mm. The headphone band width is 45mm - the width of the headphone band in the picture is 31mm.
The PETG headphone hook in the picture has been in use for 4 months - no warping.
Measurements:
The desk edge is 26mm thick. The gap for the headphone to slide in is 18mm. The headphone band width is 45mm - the width of the headphone band in the picture is 31mm.
JimmerJammer también publica en
53 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
