Thingiverse
Headphone Jack (relocated) for Behringer Wing console.
1
Téléchargements
0
Likes
0
Makes
The Behringer Wing console (full size) has a very hard to reach location for the headphone jack(s). Especially when the console is in a case. This uses a pre-built cable from Amazon - Amazon Affiliate Link - ( https://amzn.to/4r8ixes ) or you can solder your own.
I used 1/2" sheet metal screws to mount the jack inside the printed jack holder since the included screws are too short.
I utilized the side of the doghouse for a mounting location.
I considered gluing a Harbor Freight ceramic magnet to it and mounting it that way. There are notches in the design for that reason, so that is an option. I might tweak this at some point, but I also might leave well enough alone too! ;)
The design contains a flat piece for the back side of the jack that I had intended to glue on, but ultimately I didn't use it. It was just for aesthetics more than anything.
As an Amazon Associate I earn from purchases using Affiliate links.
I used 1/2" sheet metal screws to mount the jack inside the printed jack holder since the included screws are too short.
I utilized the side of the doghouse for a mounting location.
I considered gluing a Harbor Freight ceramic magnet to it and mounting it that way. There are notches in the design for that reason, so that is an option. I might tweak this at some point, but I also might leave well enough alone too! ;)
The design contains a flat piece for the back side of the jack that I had intended to glue on, but ultimately I didn't use it. It was just for aesthetics more than anything.
As an Amazon Associate I earn from purchases using Affiliate links.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !