Headphone/Keyboard Wall Mounts (Command Strip Compatible)

###Hey hey hey!

This is my first design uploaded here! I wanted to try my hand at designing something using Inventor, so here we go!

This is a set of basic wall mounts designed for use with 3M Command Strips. (Specifically the ones for picture hanging.)

I was tired of finding that most wall mounts required you to either put holes in a wall, or deal with a decent (and most times wobbly) gap between the printed piece and wall if you used strips to stick it on.

I designed these couple models with slots in the backside to account for a lot of that extra gap and ensure that these pieces would sit closer to flush against the wall.

As designed, the mounts use the following sizes of Command Strips:
- Headphone mount: 1 Large pair
- Keyboard mounts: 2 Medium pairs (since ideally you would print two of these, unless you like living life on the edge)

It took me approximately 8.5 hours to print all three out at once using the mentioned settings. You could probably reduce the