Thingiverse
Headphone Stand (Optimized for Small Printers)
door AEGISM1
1
Downloads
0
Likes
0
Makes
This is a headphone stand I designed because all of the ones on Amazon were kind of expensive for a cheap piece of metal.
I have a monoprice voxel, and that meant that the prints had to be smaller than 150x150x150mm.
My printer or slicer for some reason could not load threads so I had to use smoothbore holes and glue them together.
The material used was PLA.
PS: this may be a little tall for some, but I have a Razer Kraken and it is a little tall.
PPS: Razer sticker not included.
I have a monoprice voxel, and that meant that the prints had to be smaller than 150x150x150mm.
My printer or slicer for some reason could not load threads so I had to use smoothbore holes and glue them together.
The material used was PLA.
PS: this may be a little tall for some, but I have a Razer Kraken and it is a little tall.
PPS: Razer sticker not included.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
