Headphone Stand - "Tima"

Info on this Model:This stand can hold my Teufel Realblue´s (not the ones in the pictures) perfectly, they are pretty heavy so I would assume this can withstand most headphones weight easily.It is a 1hr 08min print on my p1s and uses about 55grams of PLA filament.Since this is printed in two pieces, there is a bit of assembly if you can even call it that.Just stick the piece in the plate the right way around and press a bit until the curve is flush with the surface of the plate. Thoughts behind this:Just trying to put some high quality nice looking stuff on my account, hope you like the minimal and sleek look.I kinda tried pushing how thin I can make the ´rod´ thing until it gets instable. I found that about 7.5mm at the bottom and 5mm at the top is the best I can do right now. (I assume for it to work like this you it is mandatory to print it on the side to use the layer-line direction to your advantage). MembershipGet a commercial license for all of my Models by subscribing.Boost MeT