Thingiverse
Headphone Stand
por fpointin
50
Descargas
63
Likes
2
Makes
Hello Thingiverse,
this is my simple and light-weight Headphone Stand.
The assembled height is 215mm (where the headphones sit on) and the 2 components fit on the Ultrabase of the Anycubic i3 mega (S).
It is divided into two parts, which can be put together (should be a fairly tight fit, I would only recommend using glue if it is really necessary).
The only needed support is at the end of the upper part.
I would be happy about any feedback, such as likes, comments, makes... :))
If it was helpful for you, feel free to use my PayPal link :D
this is my simple and light-weight Headphone Stand.
The assembled height is 215mm (where the headphones sit on) and the 2 components fit on the Ultrabase of the Anycubic i3 mega (S).
It is divided into two parts, which can be put together (should be a fairly tight fit, I would only recommend using glue if it is really necessary).
The only needed support is at the end of the upper part.
I would be happy about any feedback, such as likes, comments, makes... :))
If it was helpful for you, feel free to use my PayPal link :D
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
