Thingiverse
Headphone stand
by Eclipseguy
1
Downloads
1
Likes
0
Makes
I printed this off for a couple of friends. This is one of my first designs on Fusion 360. I printed have a.06 nozzle and printed at a .02 layer height. I used supports touching the build plate. supports are only used on the top. It is set up to use a M5x 60 bolt and a M5 nut. The bolt goes in from the bottom. You heat the nut up and push it in from the back so it stays captive. I printed the Top standing on end. It does add a lot more supports from the bottom. I wanted to keep the top as smooth as possible with as little post process. I added the Stl, 3mf and the fusion 360 file.
Eclipseguy also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!