Thingiverse
Headphone Stand
door createt
14
Downloads
7
Likes
0
Makes
Looking to spruce up your office? This two-in-one headphone and phone stand should do just that. Two different versions are available; with or without bubble patterning on the base.
Please see the printing advice provided below in *Print Settings*.
Note that this is a very large print and may take upwards of 24hrs (Ender 3 v2). Please also check that it meets the size requirements for your phone/headphones. Phones smaller than 13x80mm should fit. Also note that some of the above pictures show an earlier version of the design with no phone holder.
**Release #2 (13 NOV 2023):** Corrected orientation of STL files and provided additional sizing information in description.
**Release #3 (25 JUN 2024):** Added charger tunnel for *Base_without_bubbles*. Also enlarged phone slot on both base versions (slot measures 14x81mm, suitable for phones measuring up to 13x80mm).
More designs: https://cults3d.com/@createt
Please see the printing advice provided below in *Print Settings*.
Note that this is a very large print and may take upwards of 24hrs (Ender 3 v2). Please also check that it meets the size requirements for your phone/headphones. Phones smaller than 13x80mm should fit. Also note that some of the above pictures show an earlier version of the design with no phone holder.
**Release #2 (13 NOV 2023):** Corrected orientation of STL files and provided additional sizing information in description.
**Release #3 (25 JUN 2024):** Added charger tunnel for *Base_without_bubbles*. Also enlarged phone slot on both base versions (slot measures 14x81mm, suitable for phones measuring up to 13x80mm).
More designs: https://cults3d.com/@createt
createt publiceert ook op
23 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
