Thingiverse
Headphone table support
por Tom_57
0
Descargas
0
Likes
0
Makes
This headphone hanger has been designed to be used on LAGKAPTEN type ikea tables
The table is about 4cm thick and the hook can be placed on any side of the table except where the legs hook.
Printing does not require support is recommended and an infill of 20% with a layer height of 0.2 mm is sufficient
The table is about 4cm thick and the hook can be placed on any side of the table except where the legs hook.
Printing does not require support is recommended and an infill of 20% with a layer height of 0.2 mm is sufficient
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!