Thingiverse
Headphone wall mount
von FixAndForget
0
Downloads
0
Likes
0
Makes
headphone stand i modelled for by brother (twitch steamer) Superstooob.
(STL comes without name)
picture is an example
just use 2 sided sticky tape or other adhesives and you're away, i printed at 0.12mm layer height but would be fine at almost any layer height
i used 30% infill but if you have heavy headphones try increasing this a little.
any suggestions fire away, i'd be happy adapt it to have screw holes or a bigger base plate, cheers.
(STL comes without name)
picture is an example
just use 2 sided sticky tape or other adhesives and you're away, i printed at 0.12mm layer height but would be fine at almost any layer height
i used 30% infill but if you have heavy headphones try increasing this a little.
any suggestions fire away, i'd be happy adapt it to have screw holes or a bigger base plate, cheers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
