MakerWorld
Organizers
Go to Model
Headphones cable holder
29
Downloads
2
Likes
16
Makes
My long cable for the headphones often ended ont he floor, and then I often ended up going over it with my chair, so I decided to make this clip to not make it happen again It is designed for a 18.2mm thick table (if yours is thinner just remove the difference in the slicer, or if is it thicker just add the difference) and for a 4mm diameter cable
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
