Thingiverse
Headplay FPV battery case
door miharix
8
Downloads
4
Likes
0
Makes
Old battery of my Headplay FPV googles was bad.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
There are 2 stl files. One is ca. 40% deeper then other.
The source files(FeeCAD) are for the smaller, so you can change the writing on the bottom.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
There are 2 stl files. One is ca. 40% deeper then other.
The source files(FeeCAD) are for the smaller, so you can change the writing on the bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!