Thingiverse
Headset desk stand
door blackdeath911
21
Downloads
22
Likes
1
Makes
Just my headset stand.
Total height: ~24.5 cm
Printed in 2 parts. The top and the bottom one. After Print just glue them together at the notch. Or maybe it holds just as printed.
I designet a offset of 0,75mm to each side of the notch.
If you print this i would like to see a make here :)
If you have any questions just ask them in the comment section.
Total height: ~24.5 cm
Printed in 2 parts. The top and the bottom one. After Print just glue them together at the notch. Or maybe it holds just as printed.
I designet a offset of 0,75mm to each side of the notch.
If you print this i would like to see a make here :)
If you have any questions just ask them in the comment section.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!