Thingiverse
Headset Hanger
von ManufacturingMan
2
Downloads
1
Likes
0
Makes
This hanger has the bolt pattern that matches the control panel for the height adjustable desk available from Uplift.
The holes are 3/16" diameter with a 5/16 through hole to allow for a screwdriver.
The spacing is 3.77" on center.
I printed using Prusaslicer with the flat back oriented horizontal.
The holes are 3/16" diameter with a 5/16 through hole to allow for a screwdriver.
The spacing is 3.77" on center.
I printed using Prusaslicer with the flat back oriented horizontal.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!