Headset Holder

This is a Holder for different headsets. I tried to let it look like it's built from ASUS ROG, but that's much more difficult than expected :D

There are two Base's in the Files: One of them with the HyperX-Logo, the other one without any logo. I printed the Holder with the backside on the ultrabase.

You'll need a little bit of strenght to put the two parts together. If it's too tight, think about of using some sandpaper. You can also scale the base a little bit bigger.

EDIT: Because the most printers have now bigger build plates, I've added a combined version of the two parts just to print as one. You don't need any supports for it. There's also a normal version and a HyperX-edition. (both not tested)