Thingiverse
Headset wall mount
von snou
8
Downloads
6
Likes
0
Makes
This is a simple headset wall mount that requires adhesive tape and a soft material (foam) to make sure the headset stays in a natural position.
In the pictures I used two 15 cm model as the shelf above them is 30 cm long and I wanted them to have the same length.
Depending on your own preference, you can choose between 4 models:
15 cm
16 cm
17 cm
18 cm
You should measure how much space your headset occupies before choosing the model.
30% density is enough to keep it light and strong enough to easily withstand the weight of a headset.
In the pictures I used two 15 cm model as the shelf above them is 30 cm long and I wanted them to have the same length.
Depending on your own preference, you can choose between 4 models:
15 cm
16 cm
17 cm
18 cm
You should measure how much space your headset occupies before choosing the model.
30% density is enough to keep it light and strong enough to easily withstand the weight of a headset.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
