heart shaped (ring) box with hinge

Note: Requires 1.75mm filament!

--- Update 02/2021 ---
Added magnetic (5mm diameter, 2mm height) pressfit version. It uses 2 magnets on both top and bottom so 4 in total.

Added screenshots of printed results.


------
After printing connect 2 pieces together with 1.75mm and cut off the excess.

If the filament wont fit into the holes, sand the filament or if the hinge wont move smoothly, sand the hinge part or just open and close it until moves smoothly..

No supports required. (Flip the top part over)