Slicer Discord
Heart Theme NeoPixel LED Clock – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Heart Theme NeoPixel LED Clock

von MZip · Decor
0 Downloads
0 Likes
0 Makes
Zum Modell
Note - this action gif is of the St. Patrick’s theme clock but they read the exact same.This is a cute, fully electronic heart theme clock / lightbox without hands. The time is displayed by neopixel LEDs in the hours positions with fine location being set by the relative brightness of the minute color on either side of the minute value. The seconds value works the same as minutes. The hearts in the center of the clock face light up red. It's for desk, counter, or shelf display and the power is simple USB. If desired, it chimes the quarter hours and makes a soothing authentic tick-tock sound. This project does not require soldering though there is a splice needed to add enough length to the pushbutton switch. I used “solder splices” that do the soldering for you. All the parts specified have plug or screw terminals or wires. The hardest electronic task is cutting the wires to length, stripping the ends, and getting the wires into the correct terminals. Electronics cost is about $60.
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen