Slicer Discord
Heat Bed Wire Mount – 3D-Druckmodell von Thingiverse Thingiverse

Heat Bed Wire Mount

von chuteroo
17 Downloads
11 Likes
0 Makes
Zum Modell
The Thing:
A heat bed wiring fastener that helps provide mechanical support to preserve the integrity of the solder joints.

To Print:
1x Heatbed Clip
2x Heatbed Clip Bar

Vitamins:
Small bolts and nuts to secure the parts together. I used Nylon Lock Nuts Screw Fastener Zinc Plated Black Hex Insert Female M3x0.5mm and M3x14mm Screw Cap Point Hex Socket Screws Bolts.
Epoxy

How to Use:
1). Thread wires through gap in "Heatbed Clip"
2). Position "Heatbed Clip" such that it gently presses the wires against the edge of the heat bed and temporarily clamp it in place
3). Solder wires to the appropriate terminals on the heat bed
4). Screw "Heatbed Clip Bar" onto wires against "Heatbed Clip" using the holes closer to the heat bed. Tighten until the wires cannot move easily. Repeat with distal holes.
5). If satisfied with solder joints and positioning of all parts, epoxy the "Heatbed Clip" to the bottom of the heat bed. Clamp in place until dry.
6). Happy printing!


The
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Nylon
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen