Heat Insert Press

###Gravity press for setting heat-set inserts in plastic parts.

Fusion 360 model is here for reference:
https://a360.co/3s0OgyT

## Notes
- You may need to adjust the brake plate spring retainers to accommodate your spring size. I found that putting a slightly heavier spring at the bottom of the brake assembly helped keep the arm in position best. Also, the spring retainers are not centered. This is intentional so make sure the spring aligns with the center of the wheel. If it does not, simply rotate the plate 180deg.
- The arm assembly may need adjusting to fit up to your Iron diameter.
- I also added an extra channel nut and screw at the bottom of the rail as a wheel stop to prevent the iron from slamming into the base plate. (shown in pictures but nut listed in parts list)

##Non printed parts list:
(1) Variable temperature soldering iron
(1) 3/4" x 12" x 12" MDF
(1) 2040 450mm Aluminum Extrusion
(4) 24mm Plastic Pulley Wheel with Bearing Idler Pulley Gear
(2) 5mm bo