Heat Tower G-Code Mod ver 1

UPDATE 5 Jan 2021:

Uploaded two files to correct for pause for temp issues; version 3 only pauses for temperature, while version 2 pauses for temperature and an additional 30 seconds. Let me know there are problems. Please provide manufacturer, model of equipment, and firmware version. Version 1 has been removed.


Disclaimer: Using modified G-code is not recommended by Dremel and there is potential to damage your 3D Printer. Use this file at you own risk.

Using Heat Tower from Akiland (https://www.thingiverse.com/thing:2223651), the G-code was modified for a Dremel DigiLab 3D45 Printer in order to allow temperature changes at specific locations in the print - details below.

The G-code has been modified to start at 240°C and decrease to 190°C in 5°C increments.At each change in temperature, the print head will move to X:50mm and Y:50mm for 30 seconds. During this dwell time, the temperature will drop and after 30 seconds the print will resume until the end.