Height Gauge

This is a height gauge I wanted for my shop on the table saw and router table.

I made it so it can be calibrated before use. I took the time to lightly sand the top of the calibration flange to sharpen the points just a bit to increase the accuracy of the gauge.

The rule holder can either ride the tool or bit up to the desired height or you can set a height and lock it in using the rear knob.

I ran a 4mm tap into the locking knob hole so that it would screw in and out smoothly without any resistance.

I put 4mm holes in the rule holder and the feet of the gauge body for small magnets. The gauge also uses the following...

4 pcs. 4mm x 10mm cap screws for the calibration flange
4 pcs. 4mm flat washers for the calibration flange
1 pcs. 4mm x 30mm cap screw for the rear lock knob (use a touch of CA or tap the locking hole in the gauge body so that the knob will not spin freely on the screw)
1 pc Starrett 6" steel rule part number C303R-6

If you have any suggestions