Cults3D
Gadget
Zum Modell
Variable pitch propeller
756
Downloads
48
Likes
0
Makes
This is a study of the operation of a variable pitch propeller.
This model is freely available to adjust or modify the assembly to suit your use.
You still have the choice to adapt the motorization, the servo-motor as well as the fixing of the set on your model.
I recommend that you glue all the ball bearings to the plastic structures to avoid problems when operating the propeller, a balance of the blades is imperative to avoid vibrations.
Non-printable element necessary for the realization:
-axis 3mm diameter, 85mm long.
-axis 2mm diameter, 75mm long.
-4 ball bearings D int 3mm, D ext 6mm, E 2.5mm.
-4 ball bearings D int 10mm, D ext 15mm, E 4mm.
-3 screws of 1.5mm diameter 5.5mm long
An assembly manual is available.
Part updates are already under study and soon available.
This model is freely available to adjust or modify the assembly to suit your use.
You still have the choice to adapt the motorization, the servo-motor as well as the fixing of the set on your model.
I recommend that you glue all the ball bearings to the plastic structures to avoid problems when operating the propeller, a balance of the blades is imperative to avoid vibrations.
Non-printable element necessary for the realization:
-axis 3mm diameter, 85mm long.
-axis 2mm diameter, 75mm long.
-4 ball bearings D int 3mm, D ext 6mm, E 2.5mm.
-4 ball bearings D int 10mm, D ext 15mm, E 4mm.
-3 screws of 1.5mm diameter 5.5mm long
An assembly manual is available.
Part updates are already under study and soon available.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
