Helldivers Helmet/Skull (Display)

! The model shown in the picture was painted ! Helldivers Helmet display for your shelf / setup (12cm high). Already print-ready. The parts need to be glued together, while the connector helps to find the right position for gluing.The print plate model is a bit tricky to clean up and there will be a seam line down the middle, which you can fill with pollyfilla and coat it with a primer to make it less to none visible.You can also try to slice the raw helmet by tilting it on the chin at an angle, to print the helmet as a whole piece, but the risk of the print failing will be higher.If you find a better way to slice the helmet without a noticeable seam line, you can share it in the comments.Boost MeIf you like my work consider boosting. Your support inspires me to create new things!