Hello Darkness HueForge

AI image - source community public gallery.Then used HueForge v0.8.1 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.Size 150x200mm. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.72mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.Filaments Used:PLA Elegoo + Black Transmission Distance: 0.3PLA Elegoo + Gray Transmission Distance: 3.0PLA Elegoo + Beige Transmission Distance: 5.8PLA Elegoo + White Transmission Distance: 7This print uses 4 unique filaments Swap Instructions:Start with Black At layer #10 (0.8