HelloBaby HB6550 Crib Mount

# Summary
Printed mine on an ender 3 V2 with standard filament settings. No rafts or supports were required even though my slicer recommended it. I modeled this in fusion 360 to make sure the parts lined up. I attached the project archive so you can make necessary adjustments. You may have to adjust the grips a tiny bit depending on the crib you mount it on. The current size of the gap is 28 ish mm. It does have a hinge of sorts that has three holes where you can adjust the tilt of the camera.

## Print Instructions:
- No supports or brims needed
- use Fusion 360 to adjust the gap on the grips
- You will need two of the Pin prints. I somehow messed up the threads so they screw on backwards. Use some finagling and they should screw together eventually
- Print!

For the camera mount, there was a piece included with the camera (its a little black piece) that I screwed in to the top of the hinging piece. I had to offset the piece a little and then screwed through the print to