Thingiverse
HelloBeePrusa Anti-vibration feets
by Swaty
9
Downloads
3
Likes
0
Makes
These Feets making your HelloBeePrusa to a silent 3D Printer.
You need for the 4 Outsides part "Fuss T1-2" and "Fuss T2-2" one times per Edge.
For the middle section you need "Fuss Mitte T1-2" and "Fuss Mitte T2-2" one time for the Right, and mirrored for the Left side.
Print on 0.25mm Layer high, without Support Mat.
Put Part 1 and 2 togehter and set it under your Printer.
enjoy the silent..
You need for the 4 Outsides part "Fuss T1-2" and "Fuss T2-2" one times per Edge.
For the middle section you need "Fuss Mitte T1-2" and "Fuss Mitte T2-2" one time for the Right, and mirrored for the Left side.
Print on 0.25mm Layer high, without Support Mat.
Put Part 1 and 2 togehter and set it under your Printer.
enjoy the silent..
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!