Thingiverse
Hemera(Hermes) CR10 Mount
door Creidhne86
2
Downloads
1
Likes
0
Makes
I designed this as I wasn't 100% pleased with the build area lost by the CR10 Hemera mounts available on thingiverse
This design is intended to be fabricated from 1/8" (3.175mm) thick aluminum, but could be 3d printed as well. It uses some McMaster Carr hardware for mounting 4x 92010A116 and 2x 92010A332.
https://www.mcmaster.com/92010A116/
https://www.mcmaster.com/92010A332/
The mounting bracket would need to be mounted on the gantry first, as the screw access is blocked by the Hemera. A hole is also needed to be drilled through the gantry to access the mounting holes of the Hemera.
I haven't identified a good cooling duct solution, yet. I'll update here when that is solved.
This design is intended to be fabricated from 1/8" (3.175mm) thick aluminum, but could be 3d printed as well. It uses some McMaster Carr hardware for mounting 4x 92010A116 and 2x 92010A332.
https://www.mcmaster.com/92010A116/
https://www.mcmaster.com/92010A332/
The mounting bracket would need to be mounted on the gantry first, as the screw access is blocked by the Hemera. A hole is also needed to be drilled through the gantry to access the mounting holes of the Hemera.
I haven't identified a good cooling duct solution, yet. I'll update here when that is solved.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
