Hemera Volcano 40x40 Fan

this is my first upload

i was creating a 3dprinter and i was stuck on a problem .the cooling fan
to reduce the numbers of part i would like to use the same type of fan of the hemera 40x40 and a E3d Volcano hotend.
and i make this.

-The 40x40 fan tight fit
-there is a BLtouch mount that need tuning height
-the fan nozzle is center to the hotend
-Mount screew fit to the 4 square nut hole

My Setting:
-Made on Anycubic Predator
-You will need to drop it on the side to prin it
-Layer Height 0.2
-25% infill
-Raft
-the model Need Support

P.S. Sorry for the Quality of the Picture