Thingiverse
HemeraXS Cable Chain Bracket
por MrNeener
1
Descargas
3
Likes
0
Makes
I needed a bracket to attach a cable chain to my HemeraXS extruder, but didn't have any screw holes to use. This fits snugly around the extruder motor and will connect directly to the cable chain pieces in the referenced remix.
The dovetail has a 0.4mm tolerance built in which may be too much for some.
I'd advise doing a test print of the first few layers to make sure the two halves will fit together.
Print with flat sides down, using supports on the build plate only.
I used 3 walls and 15% infill on the one in the pictures.
The dovetail has a 0.4mm tolerance built in which may be too much for some.
I'd advise doing a test print of the first few layers to make sure the two halves will fit together.
Print with flat sides down, using supports on the build plate only.
I used 3 walls and 15% infill on the one in the pictures.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!