MakerWorld
Other Hobby & DIY
Zum Modell
Herb Grinder V4
3.9k
Downloads
496
Likes
2.7k
Makes
IMPORTANT!!Only use PETG or ABS for this Grinder! PLA is too weak!Hello There,Just a simple Herb Grinder with a fitting for a 5mm x 3mm magnet. The Magnet can be either pressed (depending on the material used and print quality) or glued. The teeth should be strong enough to not break if not packed fully and twisted with too much force (didn't break for me yet). Try to break up the herbs before putting them in the Grinder. It should grind the Herbs to about a 2mm particle size.Use PETG or stronger Plastic!!!! (Should also work without the magnets but won't keep closed of course) If you have any recommendations I'll be glad to hear them! Have fun!Other Models:Tip/Filter MouthpieceEdit:I added 2 new print profiles, one with 5x2 magnets and one with 5x3 magnets, and tuned the print profile settings to print better and a bit stronger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!