Thingiverse
HERO 5-6-7 Face Protector
by starmaid
7
Downloads
5
Likes
0
Makes
A simple print that protects the front, primarily the lens, of a GoPro 5, 6, or 7 from impacts. The protrusions do not interfere with the view, even on SuperView. I use it for my FPV drones, where crashing headfirst into hard objects is not unlikely. Inspired by the ethix gopro facehugger mask. I saw that case, forgot about it for a couple days, and then modeled this without looking it up again, so its got some differences.
Print on its side, where the lens side is closer to the bed. Supports should be used internally.
I used TPU with one perimeter and 10-15% infill, this makes it relatively flexible.
Leave a comment if you want slight changes, this is more of a draft - but it works well enough. Also, if ninjaflex ends up being too flexible, comment the settings you used to make it more sturdy. I don't have any of that stuff.
Print on its side, where the lens side is closer to the bed. Supports should be used internally.
I used TPU with one perimeter and 10-15% infill, this makes it relatively flexible.
Leave a comment if you want slight changes, this is more of a draft - but it works well enough. Also, if ninjaflex ends up being too flexible, comment the settings you used to make it more sturdy. I don't have any of that stuff.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
