Thingiverse
Electronics
Go to Model
Hex Battery 18650 holder
82
Downloads
76
Likes
0
Makes
You can stack together multiple pieces together.
Printing:
- 0.2mm to 0.3 mm of layer height
- Infill: 0% or 100% are ok.
- Orientation: I suggest putting the crown part up, as the quality is going to be slightly better.
- Support: Not needed if you print the crown part up.
Freecad file included for customization.
Printing:
- 0.2mm to 0.3 mm of layer height
- Infill: 0% or 100% are ok.
- Orientation: I suggest putting the crown part up, as the quality is going to be slightly better.
- Support: Not needed if you print the crown part up.
Freecad file included for customization.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
